J'ai postulé via un établissement d'enseignement supérieur ou universitaire. J'ai passé un entretien chez Texas Instruments (Bengaluru) en sept. 2015
Entretien
TI visited our collage in September.The first round is online test which consists of two sections 1)tecnical 2)aptitude.Technical consists of basic questions which are really logical,one should be good in network theory(rc transients),analog(opamps),control systems(bode plot).After 1st round i was selected for telephonic interview,in which i was asked basic questions on rc transcients,opamps,fourier series.After that i was called for F2F interview at Banglore where i was asked questions mainly on opamps(input resistance,output resistance based questions),some digital questions based on mux,rc transients etc
Questions d'entretien [1]
Question 1
one should be perfect in rc transients,opamps,Thevinins based questions using opamps,better to have some basic knowledge on digital
fundamental circuit intuition, problem-solving skills, and deep understanding of device physics rather than just rote memorization of equations. You will be expected to think out loud, draw waveforms, and analyze small-signal
J'ai passé un entretien chez Texas Instruments (Bengaluru)
Entretien
Online Assessment followed by 2 rounds of technical interviews. Online Assessment consisted of 3 parts - Analog, Digital and Aptitude. Analog part mostly consisted of questions from RC circuits, Opamps, MOS Circuits, Oscillators.
J'ai passé un entretien chez Texas Instruments (Bangalore Rural)
Entretien
I am only having only one round of interview
Where they asked mostly about rc circuits. Op amp basics and mosfet questions.
The interview almost happened for 1 hour and it is a good experience