J'ai postulé via un établissement d'enseignement supérieur ou universitaire. J'ai passé un entretien chez Texas Instruments (New Delhi)
Entretien
I applied for texas instruments through university.The very first round was online test which consist of aptitude and two sections one analog+network and other was digital.Based on your marks in respective section you'll be shortlisted for the interview.I got shortlisted in analog profile.The interview took place about a week after the online test.
Questions d'entretien [1]
Question 1
Interview was purely technical checking whether your basics are clear or not.I was asked questions from Network.They asked me basic network question like find current in particular branch and then they jumped into transient and RLC network questions.
J'ai passé un entretien chez Texas Instruments (Bengaluru)
Entretien
Online Assessment followed by 2 rounds of technical interviews. Online Assessment consisted of 3 parts - Analog, Digital and Aptitude. Analog part mostly consisted of questions from RC circuits, Opamps, MOS Circuits, Oscillators.
J'ai passé un entretien chez Texas Instruments (Bangalore Rural)
Entretien
I am only having only one round of interview
Where they asked mostly about rc circuits. Op amp basics and mosfet questions.
The interview almost happened for 1 hour and it is a good experience
Keep your basics clear and intuition well prepared. Knowledge in RC and small signal is must. Himangshu Agarwal and Chembiyan T must and basics of opamp etc. Input and output impedance calculations etc.