J'ai postulé via un établissement d'enseignement supérieur ou universitaire. Le processus a pris 4 semaines. J'ai passé un entretien chez Texas Instruments (Dallas, TX) en oct. 2016
Entretien
Applied through university and had one round of phone interview.
Then had a follow up interview on webex.
I was selected for an on-site interview for the final round in Dallas. It was mostly based out on the resume and a few very basic questions about the projects
Questions d'entretien [1]
Question 1
What is the purpose of kelvin connection to measure the resistance of a wire?
Which region of the transfer characteristics represent an ohmic resistor?
He gave me a 3 end to end diode connected transistors and asked me to find the voltage drop across each of them.
J'ai passé un entretien chez Texas Instruments (Bengaluru)
Entretien
Online Assessment followed by 2 rounds of technical interviews. Online Assessment consisted of 3 parts - Analog, Digital and Aptitude. Analog part mostly consisted of questions from RC circuits, Opamps, MOS Circuits, Oscillators.
J'ai passé un entretien chez Texas Instruments (Bangalore Rural)
Entretien
I am only having only one round of interview
Where they asked mostly about rc circuits. Op amp basics and mosfet questions.
The interview almost happened for 1 hour and it is a good experience
Keep your basics clear and intuition well prepared. Knowledge in RC and small signal is must. Himangshu Agarwal and Chembiyan T must and basics of opamp etc. Input and output impedance calculations etc.