Le processus a pris 1 jour. J'ai passé un entretien chez Apple (Austin, TX)
Entretien
Only made it to the second part but the first interview was a technical round. My question were to analyze a clip design and describe why geometry is important. Also asked about the properties of the material.
Questions d'entretien [1]
Question 1
What is a good way to ensuring a laptop stays close? Can you look at a clip of so detail the importance of geometry.
J'ai passé un entretien chez Apple (Shenzhen, Guangdong)
Entretien
i had my interview today and was asked the same question. also similarly, the interviewer had no sense of humor. it was not a enjoyable experience because i think i gave like 3-4 different ways of making a cantilever, but i was asked "what else?" like 10 times for the cantilever problem alone. i also have 7 years of work experience, but there was 0 question asked about it.
Questions d'entretien [1]
Question 1
What causes corrosion, and how do you design to mitigate it?
The interview went well overall. The interviewer opened with a discussion about a project I'm proud of, then a beam scenario question that covered structural and load analysis, stress and deflection, and material selection — testing my ability to connect first-principles thinking across the full problem space.
J'ai postulé via un établissement d'enseignement supérieur ou universitaire. J'ai passé un entretien chez Apple (Cupertino, CA) en avr. 2026
Entretien
Interview with hiring manager then virtual onsite. They ask you general mechanical engineering questions as well as questions dependent on type of team and skills they are looking for. Not bad overall just brush up on basic beam deflection, GD&T, Design analysis etc.